-
FREE MEMBER
NO Posting or PM's Allowed
L2A2 SUIT question
Hey All,
I just got a L2A2 Sight Unit, Infantry, Trilux off the internet & would like to know how one installs the LED retrofit kits. Is this something I can do myself or should I take it to my gunsmith?
Thanks in advance!
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
01-12-2010 08:24 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Pretty simple really. You just need to remove a circlip that holds the illumination "switch" in place. Pull out the "switch" and push in the led unit.
-
-
When you do, make sure that you get rid of all the grotty paint etc etc that will drop into the hole BEFORE you insert the new LED. Use a soft brush or and air brush to blow it out because it doesn't half make the new LED and circlip hard to get back in.
The originals only had a ten year use life and they're all well finished now
-
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks, Peter. Sorry for the delay in thanking you. I've got four projects going out on Friday & a shattered tooth to boot!
Thanks again!
-
FREE MEMBER
NO Posting or PM's Allowed
just get-off the ring on the top and after replace the "no-tritium" with new led.
for get off the ring you need a special clamp.