Types of wood used in original production

[painter777]

I often wonder if the supposed 'Walnut Shortage' was merely a low stock on hand, while waiting for more walnut to be dried.
The country was still reeling from the depression and most furniture makers were producing very little. In fact the WWII stocks.. ETC contracts saved many from going under.
Even with the combination of kiln and air drying, to make walnut suitable for gunstocks it needs a few years to dry. Most say well over 5 years. Even at this, much of it was rejected. Keep in mind the amount of factory repairs that were expected per stock. IIRC roughly 10% of the labor per stock could have been spent on such repairs. Many were patched during production and shipped as so.

I also wonder since these furniture makers used a lot of maple in the 40's why soft or hard maple wasn't considered. Or was it? Tight grained with both being nearly as dense as walnut. Much tighter than birch. Maybe cost was a factor in it's use.

Oak is to open grained making it hard to seal, has heavy grain lines that easily splintered or cracked. When wet it warps easily. Both white and red oak have very little natural oil in them.

Not taking replacement or post war into account, I've seen......
M1 Carbine Stocks made of....
Eastern Black Walnut....... used by all makers
Birch...used on type III stocks for...Underwoods, Trimble for NPM, and IBM stocks marked SC-B, Stan Pro marked S-HB
Black Cherry...... used on type II Rock-Ola stocks.

M1 Carbine Handguards,
Type III 4 rivet
Birch....... marked HI

You have to remember unlike the hand made stocks prior to WWI, WWII stocks were being mass produced.
The vitals of the pre WWI wood like,
Grain flow, Hardness and closed pores, Over all color, Figure and lengthy curing times were lessoned for the mass production of what was designed as a back lines weapon.

Look closely at the workmanship of pre-WWII stocks and you'll see the WWII stocks were well made but clearly mass produced. The machinery was now available to do so.

JMO,
Charlie-painter777

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[dbarn]

Thanks Charlie, your expertise is greatly appreciated.