-
Legacy Member
E-BAY Rear Sight Puller Mods
A couple of weeks ago, I bought this sight puller off of e-bay. It looked like it would do the trick, and a little less pricier than what the usual is, so I bought it. Well the way it was, it would work fine on flip sights, but a type 2 or 3's windage knob hangs down below the plane of the dovetail and no allowances were made on this puller when I got it. I took it to my cousins machine shop, milled 0.80 off the top of each fixture, and had to mill back the boss of the puller plunger. I had to do this for clearance of the windage knob. You can see by the pic's now that I have ample clearance for the windage knob when either removing or installing. The little jeweler's screw driver show's the clearance now. Neither of the top clamps are tightened down, I just snugged it up for the picture's.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by Rustship; 05-23-2010 at 07:17 AM.
-
The Following 3 Members Say Thank You to Rustship For This Useful Post:
-
03-29-2010 09:59 PM
# ADS
Friends and Sponsors
-
Legacy Member
Nice work! It's funny how many things these days has to be rebuilt or modified in order to work properly.GK
M1a1's-R-FUN!!!!!!!!!!!!!!!!!!!!!!!!
TSMG's-R-MORE FUN!!!!!!!!!!!!!
ENJOY LIFE AND HAVE FUN!!!
-
Thank You to shadycon For This Useful Post:
-
-
Legacy Member
Looks good Rusty, you and your cousin might have something going there.....Frank
-
Thank You to frankderrico For This Useful Post: