-
FREE MEMBER
NO Posting or PM's Allowed
Can't ID No4MK1 rifle ...
-
04-11-2010 12:46 PM
# ADS
Friends and Sponsors
-
If you post the first few numbers of the serial number, we can probably ID it from the serial number block assigned to the different manufacturers
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Serial #: K0203xx
Thanks!
-
FREE MEMBER
NO Posting or PM's Allowed
-
FREE MEMBER
NO Posting or PM's Allowed
ID
Its a Fazakerly made NO4 which has gone through Factory Through Repair at some point in its life, probably in the 50's. The sight is made by Fazakerly with an acceptance stamp. The barrel has been checked for accurate headspace and nitro proofed.
-
The serial number looks in the photo to be C20329, which is consistent with Fazakerley. It also looks like the serial number is stamped on the barrel just below the wood line in the picture.
I see the action has already been drilled for a scope mount, are you going to hunt with it?
-
-
FREE MEMBER
NO Posting or PM's Allowed
Hi Amatikulu,
Thanks for the information. I am planning on hunting with it once I get it cleaned up. I am definitly planning on going for deer with it and hoping that it is powerfull enough for moose, though I still have to research this.
It looks to me like the rifling is in good shape, but the biggest problem I have right now is that the action is very, very stiff the last inch or so, when it seems to engage with a part under the bolt itself (I apologize for not knowing the names of all the parts yet, I am still learning). I am hoping that some oil will loosen it up but I am not sure what exactly to try first.
Actually, I am thinking of doing the following to the rifle:
1) Cleaning out the barrel with some barrel solvent.
2) Lightly oiling the barrel.
3) Cleaning the entire rifle exterior (there is quite a bit of fine, red powder in places. My first thought was "rust" but all the parts still seem black and it has a pretty good bluing).
4) Removing and cleaning the bolt.
5) Lightly oiling the bolt and the part under the bolt it interfaces with.
6) Bringing it to a range to test fire with the flip sight.
If all goes well after that then I plan on getting some type of scope. I am just starting hunting (never been before) and I heard these type of rifles are accurate and last forever, so when I saw one for $150 I snapped it up.
From the look of it do you think it is worth $150?
Thanks again for your help.
-
FREE MEMBER
NO Posting or PM's Allowed
Hi M47C,
Thanks for your help.
Could I ask you - what does "accurate headspace and nitro proofed" mean? I apologize for being a "noob"; I am just starting to get into hunting and gun collecting.
Thanks !
-
FREE MEMBER
NO Posting or PM's Allowed
-
Legacy Member
All Lee turnbolt actions require the spring compressing during the closing stroke of the bolt, so that is why the final inch is hard to push.
'Headspace' on Lee-Enfields, can be considered as distance between bolthead face and the recess on the rear of the barrel on which the cartridge rim sits. It is measured with proper Go/NoGo gauges, not gaffer tape, beer can shims, strips of cardboard or other expedients. Americans seem obsessed with this, perhaps because they get sold all the junk guns that are unsellable to other gun-owning countries, or maybe because it's easy to change by parts substitution (although this opens up other problems). Many of the L-Es sold in America seem to have been separated from their correct bolt over the years and this increases the likelihood of a problem.
British commercial proof marks are visible, a form of testing required by law in most nations with any sort of a gun industry, with the glaring exception of the United States.
-
Thank You to Mk VII For This Useful Post: