-
Legacy Member
M1 Garand cleaning kit questions
How do you use the T handle multi tool in a M1 garand kit.....more specific how do you use it to disassemble the bolt ?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
09-03-2010 01:54 PM
# ADS
Friends and Sponsors
-
Advisory Panel
Screw one piece of rod on then put the screwdriver end in the chamber. Carefully close the bolt on the tool. Start with the rod over to the right. Hold the bolt closed. Shift the rod to the left and the extractor will pop out. The firing pin is loose in the back and the extractor will come out the front. Some perform this with only the op rod and bolt in the receiver.
-
-
-
Advisory Panel
(Deceased Feb 2023)
Actually the screw area is not meant for use, other than as a cleaning rod. The hole in the handle is the proper way to use the rod to either loosen the lock screw, or remove the extractor. Screwing it in can bend or break the threaded area if under tension.
-
Thank You to Bill Ricca For This Useful Post: