WRA operating rod, "R"?

[Garandrew]

I can find no "W" inside this WRA operating slide box..circular machining marks are unmolested..there is an "R" on the rail..again this is 1108196, no "W" on hammer..anyone else have a letter on rail?





Note punch mark

Spring tube, bull nose hand guard,

with Lyman front sight too

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Bubba-7]

I found two Winchester type 1 slides in the spare parts bin, W in the box. One with a N and one with an O near the location of the R on yours.

[Garandrew]

Thankyou Bubba

[JOHN42768]

I have a 1.07 with W in bottom of box and M on the arm. Hard to tell ,but looks a little like the bottom half of the W about a inch in from end below the line amongst the mill circles. John

[Garandrew]

Ive used a loop, its not a W...no letter at all, but I know it is WRA..