Well,

3 test-fire sessions later, and I'm kinda frustrated.

Some folks might recall that I messed up my extractor slot a bit? My "new" extractor isn't working quite right, and though I'm getting the action to cycle properly now, I'm not ejecting the empties.

So, I'm at the point I think, where I need to mill the slot for the ejector a bit deeper, and lengthen the ejector a bit.

Will dabbing a bit of weld onto the end of the current ejector and filing/dremeling it down to shape work, or do you think I need to cut it out and put in a new one?

NS
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.