Carbine Stock

[cmrtwister6115]

What type of stock Low or High wood on a Inland ser#2,997,xxx carbine?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[usgicollector]

highwood oval cut oiler slot

[Bill Hollinger]

X 1

[mjanway]

And if you find some, pick up one for me for a 2953846.

[BrianQ]

This is the tock on Inland 2,954,xxx. It is a highwood, I cut. Is it correct for the serial number?

[Bufordm1]

I know I've seen earlier serial numbered Inlands, supposedly correct, that had oval cut highwoods. One was #987,xxx. I would guess the I cuts would have continued to be used (mixed with the ovals) till they simply ran out of them. Easily putting them into that 2.9 mill. range. So I guess yes...correct.

[cmrtwister6115]

Thanks for the help guys, mine has the Low Wood.

[usgicollector]

If it is RMC marked in slingwell I would say yes, but I would say to late if it was an H.I. or OI stock

[BrianQ]

Here's the sling well marking.

[dbarn]

Here's the sling well marking.

https://www.milsurps.com/images/impo...MCIstock-1.jpg

You have seen the loose RMC I marked stocks with the Inland acceptance stamp, and you can read about them in the books, but it's great to see an original example and serial number that Inland actually used this stock. I remember when you bought this one. Glad it went to a good home. Great find.