So I have the projetc I'm on at present and I'm workign on stockign up this No.4 Mk1/2. Everything fits JUST about correctlyu, draws are tight and levaing marks where the metal contacts the wood. no daylight betweene forend and buttstock. There is ONE small detail.
when the receiver is firmly pushed into the forend the barrel is high and slightly left of the center of the forend. When the barrel is in the groove the reciever is slightly high at the rear. The pivot point appears to be just about where the king screw goes but i cannot see any specific places where there is contact more than anywhere else. Plus it's only slightly high. should I leave this as it and fit everything else and see how it settles or does this need to be dealt with now, and if so how do i figure out the exact place that needs to be relieved?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.