-
Legacy Member
Faz No. 4 Mk 1?
Picked up this rifle at a pawn shop this week. There is no manufacturers marking anywhere on the rifle and the butt socket is stamped with the serial number 20051 and under that the number 41. On top of the receiver is a star with a W inside the star.
I am assuming that this rifle was made at Fazakerly because their serial number range started at 20000. If so, would this be the 51st rifle they produced?
Thanks
Bren
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
08-26-2011 12:42 PM
# ADS
Friends and Sponsors
-
Does it look similar to this?
-
Thank You to Amatikulu For This Useful Post:
-
-
Legacy Member
Funnily enough, I bumped into a similar rifle today, with the following marking on the buttsocket:
ROF
1941
2****A
The rifle was missing the front hand guard and the front sight protector, but the rest didn't look in too bad condition. The bolt head was a No.4, but these rifles had a rough life. The rear sight was a Mk.2. I could not find anything that would make me think the rifle had undergone any major FTR program. I think I can talk the guy down to $150, and it would be a relatively easy job to find the missing parts.
-
Thank You to spinecracker For This Useful Post:
-
Legacy Member
Yes sir it does. Now to figure out what the W in a five pointed star is.
Thanks for the reply.
Bren
-
-
Legacy Member
That same "W" mark is on my 1941 Long Branch. I would love to know precisely what it means.
-
-
Is it the Weedon Repaired sandard mark? I thought that star had 6 points though
-
-
Now that's just weird. Bren's and Amatikulu
's rifles are exactly 1000 apart!
Neither "A" suffixed. Does either one have the charger brige welded in place?
Spinecracker, same question would apply to the one you are looking to buy. (Do It!)
ETA:Added link to another thread not directly relevant to this one, unless it is!
"...actively sought out and destroyed..." 'A' Suffix No.4 Rifles
Last edited by jmoore; 08-27-2011 at 11:00 AM.
-
-
Here's a side view of the charger bridge for jmoore
-
Thank You to Amatikulu For This Useful Post:
-
Legacy Member
I could not tell if the charger bridge was welded or not. I must admit to have been a little distracted as I had just undergone a surgical procedure and was in some discomfort. If I go back, then I will double check.
Last edited by spinecracker; 08-27-2011 at 12:00 PM.
-