I think I have to join the chorus on .223 conversion. I heard that it could be done too, so I used a pipe cutter and ran them through the sizing dies (without the neck expander in place) Trimmed to length, then turned the necks.
after that I annealed the cases and ran them through the sizing die again with the expander button in place.
they work fine. I figure that if the supply of milsurp dries up, I'll still be shooting. Besides, the cast bullet (95 gr) works fine in the carbine and the Nagant revolver too.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.