-
FREE MEMBER
NO Posting or PM's Allowed
Pre Ban A2 on layaway
It is a my friends gun shop right now.
My question here is, was the A2 sporter ever fitted with the triangular hand guard? Mine does not have it. Thanks
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
02-26-2012 08:20 PM
# ADS
Friends and Sponsors
-
Legacy Member
-
Thank You to Skip For This Useful Post:
-
-
FREE MEMBER
NO Posting or PM's Allowed

Originally Posted by
A. F Medic
My question here is, was the A2 sporter ever fitted with the triangular hand guard? Mine does not have it. Thanks
No. If you see one that does, it's because someone swapped them to get the A1 look.
So, does yours have the slickside upper receiver, the forward assist upper, or the forward assist and brass deflector? A2 Sporters came in all three variations.
-
FREE MEMBER
NO Posting or PM's Allowed
Don't remember. Rifle is not here. I believe it has the brass deflector. So much to learn. So much knowledge here!! Thanks
I have been going here...Retro Black Rifle www.retroblackrifle.com
-
Dont forget A1 sights with brass deflector! Saw a few of those when the "A2" was introduced. How disappointing when opening the box...
-
-
FREE MEMBER
NO Posting or PM's Allowed
What is a slick side upper receiver? I think I know what a "fence" is and that appears important. Thanks...
-
FREE MEMBER
NO Posting or PM's Allowed
AF,
Check out my thread on this page/ forum. I have a slick side upper receiver that I built on. Of course I milled off the fence for the lower. Normally I don't recommend that... it is there for a reason. Regardless, you will see on the slick side upper, is the A1 type rear site. No brass deflector.... and no forward assist.
The upper was my 2nd slick side upper gunshow find.... the other technically wasn't even finished machining... but that didn't stop me!
I was planning on building a full length rifle with it (triangular handguards etc) but BAR stopped me and forced me to build a carbine! Jeez... tough guy! 
Anyway, I think I have some photos for you to gloss over..... on that thread.
-
FREE MEMBER
NO Posting or PM's Allowed
How does one access your thread? I tried but mt intellect failed me!
-
Moderator
(M1 Garand/M14/M1A Rifles)
"It is said, 'Go not to the elves for counsel for they will say both no and yes.' "
Frodo Baggins to Gildor Inglorion, The Fellowship of the Ring
-
The Following 2 Members Say Thank You to Bob Womack For This Useful Post:
-
FREE MEMBER
NO Posting or PM's Allowed
Slickside= no forward assist (or brass deflector). AR-15A2 Sporter IIs came in three variants, all with the A1 rear sight: no forward assist, forward assist alone, and forward assist plus deflector. By 1988 Colt finally began to produce a proper M16A2 equivalent, the AR-15A2 Government Model.