AMMUNITION RELOADING DISCLAIMER: Any and all equipment, materials, and data mentioned on our boards are for informational purposes only, and are not intended to promote or endorse any particular products or technique. Any and all recipes, techniques, and data are to be used at your own risk. We accept no responsibility for the use or misuse of any information found on this wed site.

Please Note: All reloading activity should be done in strict accordance of the manufacturers' specifications printed in their manuals. Milsurps.com and it's members will be held harmless of any and all information related to reloading data and the use of any ammunition submitted on these boards.

Due to the age and unknown maintenance and modifications of ex-military weapons there is always an inherent risk of personal injury including death, even when properly loaded ammunition is used. Inherently, reloading ammunition can be dangerous even in new weapons - Adding to this ammunition risk, many milsurp weapons are often well over half a century old with no knowledge of their maintenance and modifications over the many years while in civilian ownership. Milsurps.com does not endorse or take responsibility for discharging any weapon.

Results 1 to 8 of 8

Thread: Forming brass for the 7.7 Jap

03-07-2012 04:33 PM #4
Parashooter

View Profile

View Forum Posts

Private Message

View Articles
Advisory Panel

Join Date

Dec 2008

Last On
09-24-2024 @ 01:41 AM

Location

Connecticut

Age

80

Posts

680

Local Date

05-06-2025

Local Time

08:08 AM

View photos by Parashooter
Be prepared for some expansion. No harm as long as we keep pressures in the normal range.
Top PM Register To Reply
The Following 2 Members Say Thank You to Parashooter For This Useful Post:

GUTS, jmoore