bad gas cylinder?

[E.Hall 43 m1]

Chris good question.....I checked, and it will pass the tilt test, but only with the trigger group removed. It acts the same way with my old stock. Everytime I lock in the trigger group it binds. I thought it was the op rod rubbing against the stock but I did the tilt test on the op rod with the bolt removed and had no binding when I locked the trigger group. But when the bolt is in, the op rod is removed, and the trigger group locked in, it binds about half way closed.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.