Gotta love it when....

[Son]

You pull the foreend off a rifle that hasn't been dicked with in any way and find the witness marks that show it was bedded properly by the factory way back then....

In the pics, you will see the corresponding marks I have highlighted. The first pic shows the underside of the receiver with full contact onto the foreend between the butt socket and the recoil lugs, then from about half way along the magazine well, to the front trigger guard screw block. Notice the barrel knox is bedded from 3 o'clock to 9 o'clock for the length of the knox.
Attachment 35633

Pic two debunks a myth that all HT's have floating barrels. I have opened up a few, and am yet to find one that wasn't bedded in this manner, the same as the standard weight barrel service rifle. There is an inch of bedding from 5 o'clock to 7 o'clock for an inch either side of the inner band (naturally omitted from the H barrel), and then for at least the last four inches to the muzzle from 5 o'clock to 7 o'clock... this one has been bedded all the way. I would expect to find the same in any rifle from Lithgow that hasn't been altered.
Attachment 35634

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.