-
FREE MEMBER
NO Posting or PM's Allowed
84 Carbine shoots high
I shot my 84 Carbine today and I can't set the sight low enough. I was shooting old Winchester ammo with 405 gr.lead. The carbine has the Buffington carbine rear sight and the tall front sight,were they able to be set for 100 yards? or should I try different loads?TIA Lee W. P.S. 6 inches high above point of aim.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-12-2009 06:06 PM
# ADS
Friends and Sponsors
-
Legacy Member
Targets
Hmm, there is a constant drone on these boards about military rifles shooting high. It could be your target instead. Try getting cardboard cutout of a standing man and draw a belt on the figure. Then using issue ammunition, and the correct sight settings. Try sighting on the belt buckle and then move the target from 0 to 300 yards. Bet you will hit it every time. Now if you want to shoot black circles, get a target rifle. You will only need one per year, because all the bullets will go through the same hole. Try shooting for groups.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
OK Terry, I undrestand your reasoning but I thought I should have been able to adjust my sights to shoot at a 100yd target.Was that not the reason the 1890 front sight was higher than previous TD sights.Thanks for your reply.Lee W.
-
FREE MEMBER
NO Posting or PM's Allowed
Nope!
The sights aren't calibrated for targets as close as 100 yards.
Don't the graduations start at 200 yards?
-
FREE MEMBER
NO Posting or PM's Allowed
There was a reason officers went down the firing line during battle yelling "Aim low!"
Victor
-
FREE MEMBER
NO Posting or PM's Allowed
These are battle sights. They range from 200 yards to 2000 yards. Some people install a taller front blade to bring them down. This may give you a one-hundred yard sight but it will change all the values printed on the sight. Others use two targets at one hundred yards. One placed below the other. Aim at the lower one and hit the upper one. Shooting for consistent groups. Still others simple shoot high at one hundred yards. A running man with-in a hundred yards might mean its time to draw your pistol.
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks guys; I don't plan on match shooting with the carbine,I only have a 100yd range out the back door.Lee W.
-
FREE MEMBER
NO Posting or PM's Allowed
Originally Posted by
oakfarm
I shot my 84 Carbine today and I can't set the sight low enough. I was shooting old Winchester ammo with 405 gr.lead. The carbine has the Buffington carbine rear sight and the tall front sight,were they able to be set for 100 yards? or should I try different loads?TIA Lee W. P.S. 6 inches high above point of aim.
You need to try different loads, preferably handloads. The carbine sights are regulated for the 45-55 carbine load not the 45-70 service rifle loads. It is probably the velocity and recoil of the ammo you are using that is causing the 6" high groups. I'm assuming you are also talking about using the Buffington ladder sight and not the battle sight. The battle sight will group high at 100 yards as it zeroed for around 265 yards. Try working up a load with a 400-405 gr bullet with a velocity in the 1000-1150 fps range.
Larry Gibson
-
FREE MEMBER
NO Posting or PM's Allowed
these are the targets I use. I shoot a relay, rotate the target 180° and then shoot another relay
the bulls are 12" apart
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks Mark,Nice targets,where did you get them? What type are they?ie-200yd large bore? Lee W.