press stud for 1907-1913-1917 bayonet

[win1906]

looking for press studs for 1917 bayonets.i have the bolt and springs but cant find the nuts any where.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Peter Laidler]

Simplicity itself to make. While you're at it, make 10 and sell the remainder on to make a profit. Because if you need a few, then there's a good chance that loads of others will need a couple too!

Added later....... That's right BAR (see next thread). One of our fitters turned up 50 or so for needy No5 bayonets. Made a killing on the first 20 or so, sufficient profit to just give the rest away!

[browningautorifle]

I've sent you a PM, I have one here...but like Peter says, they're just round stock with a hole tapped into the center. Slightly recessed and could be done.