Ridolpho,
Thanks for the advice. Went on ebay this AM and found a very good video on how to disassemble the No. 4 rifle. Following it was very easy and I did a complete strip and clean. Found the rifle does NOT have the proper upwards pressure but more or less was free floating forward of the chamber. The rifle has a ferrule around the front action screw between the receiver and the trigger guard. Will shortening this ferrule VERY slightly help put more pressure on the rear of the barrel and a bit more upward pressure on the front?
Keith
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.