-
FREE MEMBER
NO Posting or PM's Allowed
Breda Front Handguard Ferrules marked?
I have the parts collected for building three (more, just finished the first) Breda Garands. One will have B. sig barrel, the other two will have Criterions. The only parts where I might expect a mark and don't have BMB, BMR or VAR are the front handguard ferrules, which are unmarked.
Did the Breda Front Handguard ferrules have a mark? Anyone know a source for such? I can take shipments either to a US or a Canadian address.
Regards,
Adam
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
10-11-2013 11:13 AM
# ADS
Friends and Sponsors
-
Contributing Member
Ferrule
Dunno for sure, but Beretta marked theirs so I'm guessing Breda did too.
Attachment 46501
Real men measure once and cut.
-
Thank You to Bob Seijas For This Useful Post:
-
-
-
The Following 3 Members Say Thank You to Rick B For This Useful Post:
-
Contributing Member
My Danish G/50 contract Breda has the front hand guard furrule marked 'BMR'. I have one in my junk box marked 'BMB'.
Last edited by Tom in N.J.; 10-12-2013 at 01:09 PM.
-
-
FREE MEMBER
NO Posting or PM's Allowed
Would you be interested in selling your bmb handguard ferrule? I'd be interested in buying it.
Regards,
Adam (usheral)
-
Contributing Member
If that doesn't work out, try Orion7, they used to have a ton of Italian parts.
-
-
FREE MEMBER
NO Posting or PM's Allowed
They say "no international orders or shipments to Canada". I'm ok with the no shipments to Canada, almost all the US folks I've dealt with have been unwilling to do cross border shipment. Quite a few I've talked to have been strictly no international because of the ITAR restrictions. Of course front handguard ferrule are non-ITAR, but lots of vendors can't be bothered to sort it out (for which I don't blame them).
Still, I must say that I've had a lot of help from US Garand people, or I wouldn't be in build mode now. I'm pretty happy with the first build, looking forward to doing the other three.
If Orion7 have bmb/bmr ferrules I'll contact them directly and see, thanks for the lead.
Regards, Adam