Quote Originally Posted by Peter Laidlericon View Post
Just a minute..... You shouldn't be adjusting the body when you fit a bolt. You fit the BOLT to the body. Or am I mis reading something.
Tues 4 Dec 2007 12:07 pm some bloke wrote this :

.....................BUT, that's not quite the end of the story because you won't have this 'Gauge, Inspectors, bolt' but it's only right that I tell you. Now for a little secret. If you have ever bought a rifle that has a sploge of red paint on the left side, adjacent to the internal left side locking lug, then you now know that the rifle was condemned for 'worn locking lugs'.

If you are going to fit a second hand or new bolt, then do the same thing. If the dye pattern is one sided, then stone the high surface of the bolt until BOTH locking lugs bear evenly against the locking surfaces of the corresponding surfaces in the body. BUT DO NOT ATTEMPT to stone the rifle to get a bolt to fit (you can only get to the right hand surface in any case ....). The rifle body is induction hardened at these points to a depth of .004 - .006" but we have found it deeper