-
Contributing Member
12-211 Garand Picture of the Day - Marine Raders in training
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
He is no fool who gives what he cannot keep to gain that which he cannot lose
There are no great men, only great challenges that ordinary men are forced by circumstances to meet.
-
The Following 11 Members Say Thank You to Mark in Rochester For This Useful Post:
25-5,
30-06_mike,
A. F Medic,
AZPhil,
bearrowland,
Bill Hollinger,
Bill Hughes,
Bob Womack,
CINDERS,
frankderrico,
HOOKED ON HISTORY
-
07-30-2014 12:30 PM
# ADS
Friends and Sponsors
-
Contributing Member
What rifle is the soldier third from right carrying? Maybe it's the angle, but looks to small to be a BAR.
-
-
-
Legacy Member
That's a stripped down BAR. The angle throws the pic a bit.
-
Thank You to bearrowland For This Useful Post:
-
Advisory Panel
I think if we were closer, we'd find it to be a proper 1918 BAR without mods. Checkered forend and no bipod ever installed. Also it looks like the first pattern of flash hider...wooden butt, without monopod hole. Like a Colt or Marlin Rockwell...
-
The Following 3 Members Say Thank You to browningautorifle For This Useful Post:
-
Legacy Member
It's the same as the guy behind him . It's a 1928 Thompson with the Cutts . It is twisted over so you are looking more at the bottom . Quite clear at 400 % .
Chris
-
The Following 2 Members Say Thank You to emmagee1917 For This Useful Post:
-
Legacy Member
BAR Model 1918 and 1918A1
Before the Model 1918A2 was adopted, there was a bipod adopted in 1937 for the Model 1918A1. This bipod was also used during the early part of the war until replaced by the 1918A2 This bipod was attached to the gas cylinder Attachment 55136
-
The Following 4 Members Say Thank You to RCS For This Useful Post:
-
Advisory Panel
Yes, the extreme right man is carrying a Thompson...I payed no attention to him initially.
-
-
Legacy Member
Thanks Jim! I had the privilege to meet a BAR gunner who served in the Philipine campaign. I forgot that he told me they had a lot of the original versions as the Army took most of the new ones! One constant in this life is that service rivalry never ends!!
-
-
Legacy Member
OK , I was looking at the wrong guy .
Yes , the man in question is carring a WW1 pattern BAR . It has the early wood , short buttstock with the 1917 buttplate on it . Fore end is the checkered wood and does not look like it's been cut down . The mag well ears have not been added and , as said , it has the early non-bipod flash hider . It has the early gas regulator and prob'ly is still set up for semi and full auto selection .
I would love to have it in my collection.
Chris
added PS .... of course it's semi and full , you need the later long stock with the shoulder rest to contain the two speed FA conversion.
Last edited by emmagee1917; 07-31-2014 at 01:45 PM.
-
-
Senior Moderator
(Milsurp Forums)
Robert, is there anything you don't have???
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
Thank You to Bill Hollinger For This Useful Post: