-
Contributing Member
The normal procedure for using rear aperture sights is to fit a higher front blade, this requires you to check and record your original mid barrel settings.
But as the amount of Service shoots using original sights is a very small proportion, the rear aperture when zeroed correctly, sits well above the rear sight, only getting in line at the 100yd setting.
-
The Following 4 Members Say Thank You to muffett.2008 For This Useful Post:
-
07-20-2015 05:42 AM
# ADS
Friends and Sponsors
-
Legacy Member
thanks Muffet...
hopefully i get it sorted at the range this week. most of my shoots will be at 3-500 so it shouldnt be a big issue!
-
-
-
Legacy Member
-
Thank You to S12A For This Useful Post: