Weekend gun show pick ups

[mmppres]

Hi Guys picked these to fine pieces up at local show for 150.00 total. No5 looks bent an not sure what other one is or what calibre it is yet. but price was right could always part them out an make money.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[CINDERS]

The No.5 looks worse for wear, the other may be a .22 trainer cannot tell under the rust but is that the BRNO logo, try stainless steel wool and WD-40 or RP-7 to remove surface rust I use it and it works well but it has to be stainless steel wool not ordinary stuff that will remove the bluing if you use that. You could post the results as it looks the perfect candidate for it other forumers have asked about the removal of surface rust and believe me I have used it on my rifles and it works.

[mike1967]

That No 5 looks like a Kyber Pass job, I don't think there is a genuine part on it, i would be very careful letting one go out of that.

[mmppres]

will post pictures as i can No5 bolt is solid with grease will not move an already wiped down the rust with balistol an let sit.

[Aragorn243]

That No 5 looks like a Kyber Pass job, I don't think there is a genuine part on it, i would be very careful letting one go out of that.

I was thinking the same thing, nothing looks right on it.

For rust like that I use the back side of a rounded knife blade and scrape/crush the rust. Breaks it right up, doesn't mar the finish and is fairly quick. Did an action and barrel last weekend that was similar to yours and it took two hours. I've steel wooled things to death and never gotten all the rust off. Steel wool is best for very light fine rust. I don't like using chemicals when I don't have to.

[Peter Laidler]

Photo 2 looks like it has been butchered and welded to take a 7.62mm charger clip. M Sharrif....... There's a name I seem to recall...... Maybe it belonged to the previous President of Pakistan.

[Lee Enfield]

That No 5 looks like a Kyber Pass job, I don't think there is a genuine part on it, i would be very careful letting one go out of that.

I looked at a Khyber Pass No5 around 10 years ago... it was Savage, BSA, Maltby and Fazakerly manufacture marked.

The rear sight axis was below the height of the charger bridge...

I seriously considered buying it as a curio...

[mmppres]

Hi guys used the stainless wool along with GI bore cleaner here is results. used it inside an out gun shoots great.
]

[WarPig1976]

It is amazing what they can produce with a drill press and files, literally on a rock work surface. It really is true craftsmanship all be it on a primitive level. Still wouldn't hurt my feelings to turn the place into a glass parking lot.