Looking to buy that No32 'scope.........

[Peter Laidler]

Now unscrew the ocular counter cell (the lens retaining ring) and pull out the two lenses plus the spacer

Then unscrew the OG brass ray shade and draw out the inner tube. Separate the OG lens from the inner tube

Unscrew the 4 screws and remove the locking segment from below. Push the erector cell FORWARDS until it comes out of the front/OG end

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Jsne]

Now unscrew the ocular counter cell (the lens retaining ring) and pull out the two lenses plus the spacer

Then unscrew the OG brass ray shade and draw out the inner tube. Separate the OG lens from the inner tube

Unscrew the 4 screws and remove the locking segment from below. Push the erector cell FORWARDS until it comes out of the front/OG end

Thank you Peter
Both end is very tight. And i have tryed to unscrew them with great force without any luck.
do i have to head them to soften any cement or glue?
Ore do you have any ideas to unscrew them without damage them?

Jsne