-
Legacy Member
no 4 mk1 restoration
is there any source for new furniture for a no4 mk1 ?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
07-02-2016 04:53 PM
# ADS
Friends and Sponsors
-
Legacy Member

Originally Posted by
olskool
is there any source for new furniture for a no4 mk1 ?
I Have seen these and they appear to be in good condition. But not new.
https://www.libertytreecollectors.co...&idcategory=63
-
-
-
Legacy Member
The rear top hand guard appears to be mk2 without the ribbed sides. It should fit ok if you are not too bothered about it being strictly mk1. Why not have a look on eBay as there's often No4 woodwork available on there.
-
Thank You to Flying10uk For This Useful Post:
-
Contributing Member
Be wary of flea bay the prices can get inhibitive there are stock sets in the U K at present you then have to factor getting to your local, try gun shows or Brian Dick
may be able to assist put a WTB ad on this site
-
-
Advisory Panel
I'd want a set of walnut for that I think. A WTB here for sure...like Cinders suggested.
-
-
Contributing Member
Try this one on flea bay 231998522882
-
-
Ribbed or plain rear handguards were not differently identified to us Armourers. They were all the same and equally at home on any mark/type of rifle. Non ribbed introduced in 1942 along with flat head (instead or radiussed head) handguard cap rivets by the Committee for the simplification of small-arms design. Just another of the thousands of relaxations allowed. I'm bound to ask what the ribbed handguards were meant to achieve? Unless you had hands like dinner plates, your fingers would be hard pressed to even touch the ribbed surfaces
Last edited by Peter Laidler; 07-03-2016 at 04:22 PM.
-
Thank You to Peter Laidler For This Useful Post:
-
Legacy Member
I read somewhere the ribs were to help grip when fighting with the attached bayonet.
-
-
Legacy Member
Surprising to me, at a militaria show earlier in the year one of the dealers was charging more for Beech No4 woodwork than for Walnut. When I asked him why, as I would have thought that it would have been the other way round, he replied that Beech is getting more difficult to get hold of for the No4 rifle. Obviously, this is only one dealer's view others may have different opinions.
-
The Following 2 Members Say Thank You to Flying10uk For This Useful Post:
-
Advisory Panel

Originally Posted by
Vincent
help grip when fighting with the attached bayonet
That would make more sense to me, they're in the right place for that.
-