Webley No.2 Mark1 Problem (Peter?)

[scoobsean]

Thanks for the response, browningautorifle.

The firing pin does protrude through the firing pin hole, however it leaves no mark on the primer at all. I will try to take photos.

This happened with my Enfield revolver, although I was getting a very light indentation on the primer. Turned out that the main spring needed replacing

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Drill Sergeant]

This happened with my Enfield revolver, although I was getting a very light indentation on the primer. Turned out that the main spring needed replacing

OK scoobsean, appreciate that. I have checked the drawing in the 'stickies', however cannot find where that spring might be. Can you help me to locate it. If that is the problem, I'll try to locate one and change it out.