New member in need of L41a1 IWS mount

[bigduke6]

Geoff, if you do end up making a small run of the short arms for the IWS bracket I'll gladly purchase one from you. I have had one of the longer 'J' shaped arms of an original bracket kicking about for ages, & don't in fact have a complete one myself. However, no worries if it's not possible, the other bits are more important. Have just wrapped up the gash Mk1 & Mk3 tubes for you.

Best.

No probs Rog, hope all goes well Tuesday........

Personally speaking........ I'd like to have seen a tad more input into the forum from Dan before we embarked on this aid. Sorry to say it, but 1 note on the forum and that was request - and bugger all since or forthcoming and forumers bending over backwards.................. Yep, I'm guilty of a part of the giving in this instance too. But these forums should be all about give and take with the...........

The Bren Forum is even worse for transient joiners wanting this that and the other and then............... nothing. Just something that doesn't ring true with the spirit of a forum

At least its gone well for one forum member.....,plus another will have a missing part made.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.