P14/P17 lower and upper handguard.

[fjruple]

So the trigger guard floorplate assembly is the same for both gun?

The floorplate assemblies are different for each. The easiest way tell is the front edge of the floorplate for the P14 is rounded on the front corners and the M1917 front corners are squared.

--FJR

Additionally, there are differences between P14 manufacturers. The Winchester magazine box will not be a drop in fit for the other manufacturers. The Eddystones also had two different models, a #1 and #2 which do not fit each other.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Buster95]

The floorplate assemblies are different for each. The easiest way tell is the front edge of the floorplate for the P14 is rounded on the front corners and the M1917 front corners are squared.

The above floorplate have squared corners so it's a P14 in a P17 stock with P17 bottom metal.

[fjruple]

The above floorplate have squared corners so it's a P14 in a P17 stock with P17 bottom metal.

Buster--

The floorplate looks like it's to a M1917 and the triggerguard is a P14. None of these parts are a sure fit. I am currently working on three P14s from each of the manufacturers and it truly is mind numbing to get the right parts to fit. I can see why the Empire very quickly made these rifles a secondary weapon and probably DP a lot of them for the lack of spare parts.

--fjruple