-
Legacy Member
Interesting M16/AR-15 "dust cover"
You really do not find many "dust covers' like this variationAttachment 79287Attachment 79288
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
01-05-2017 07:29 PM
# ADS
Friends and Sponsors
-
Advisory Panel
So, that one's very early? Never have I seen one without the outer bumper. The receiver is flatside and there's a large head pin so I can't see if it's a small or large hole front. I'm guessing it's a big hole AR SP1? What serial range?
-
-
-
Legacy Member
Jim, I posted the photos as a quiz, it is not really early. It looks like some of the early AR-10 dust covers. I would think someone would identify it soon ?
-
-
Contributing Member
I have one on my"retro build"... I always thought it was an early version, but I have been advised by an advanced collector that it is a non military replacement made in the 1980s to fill a need for parts.
Attachment 79293
Last edited by Tom in N.J.; 01-05-2017 at 09:14 PM.
-
Thank You to Tom in N.J. For This Useful Post:
-
Senior Moderator
(Milsurp Forums)
Not early or at least the lower in its configuration isn't. The hammer and trigger pins are later and I think perhaps Elisco???
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
Legacy Member
Tom in NJ is correct. There was a company in Northern Illinois that manufactured AR-15 uppers, at some point around 1982, they were unable to get military port covers or as the XM16E1 manual calls
them "dust covers". They decided to have a short production run of dust covers to fill the need, that is where these came from - they fooled me into thinking they are early too.
Bill, the photo: mixmaster of parts, SP1 (1974) lower with my CAR 15 stock, upper CM with my own home-made take-down pin. Fake cover looks good
-
Thank You to RCS For This Useful Post:
-
Advisory Panel
I knew the front pin was a civilian thing to make stripping easier. I can't imagine there having been a shortage of those...
-