What rear sight?

[amadeus76]

For a No.4 Mk1* rifle, what rear sights are correct? Would the milled micrometer sight be kosher?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Peter Laidler]

They are ALL correct.

[RobD]

I expect this will be an easy one for Peter et al - I was shooting my No4 Mk 1(T) with iron sights on Sunday, for the first time. I found the adjusting screw which elevates the slide has a "rotational floppiness" about it and not a definite click as it goes round.
What do I need to replace, in what sequence do I take it apart, and what goes wrong when doing it the 1st time?
I attach a diagram of the parts to help the explanation make sense to me...

[CINDERS]

I am sure Peter has mentioned a few times about a certain little arrangement (4 & 5 ?) that acts on the indents on the thumb wheel apparently it is a right little sod to fit up

[Peter Laidler]

Just as Cinders has mentioned. You need to replace the detent spring and the plunger (or ball). And guess what's going to happen......? Yep, that little ball or plunger and/or spring are going to whizzzzzzz off somewhere. Suggest that you take it apart inside a large plastic bag and assemble it the same way after having cleaned it with a dob of grease on the spring and ball.

After you've done a zillion of them it gets easier. I used to hold the leaf - 2 in a vice with the spring hole upwards. Put greased up spring in hole and ball on top of greased up spring. Shape a piece of thin shim into a squared off U section and pull the ball and spring into the hole. Press in the adjusting knob -8 secure and pull shim out then test.

You could also replace the pin - 3 if it shows signs of wear. Because the wear allows up/down endfloat of the cursor -7

[browningautorifle]

what rear sights are correct

If you'd asked what originally came mounted...it would have been the one pictured by RobD below.

What do I need to replace

I'd say they all have a certain amount of slop. I'd just change sights. Or use a PH 5C for target and then change back to the other when it's not needed...

[RobD]

Thanks Peter, I shall follow those instructions.

I didn't want to replace the original No 4(T) rearsight which has its ground-off battle sight. Hence my wanting to fix this one up. Yes yes Peter I know it would be OK in your hands but I am a sentimental fool...

As for a target sight: I use the PH 8/53 sight, which is a quick fit to the original rearsight.
I had even hoped it would flip down and allow the No 32 scope to sit above it - but no such luck - even with the eyepiece unscrewed the 8/53 sight body prevents proper seating of the telescopic sight.
Rob

[Flying10uk]

For a No.4 Mk1* rifle, what rear sights are correct?

Did you intend to say, what rear sights were originally fitted by the Long Branch and Savage factories to the No4 MK1* rifles which the 2 plants manufactured during the period of WW2? Was the micrometer adjustable rear sight originally fitted by the 2 factories to the No4 MK1* rifle during the WW2 period or would this sight have been retro fitted to this rifle (MK1* version)?

[Peter Laidler]

Nope...... I didn't understand it either! What Mk2* are we on about?

[browningautorifle]

What Mk2* are we on about?

No one asked about a Mk2*, that's why. Both of their questions were clear...