Hi all, back again. I have finally started serious work on the Bren. The stock and grip have been very lightly sanded and cleaned with mineral spirits, then boiled linseed oilicon was brushed on several times after 24h of curing.

All the parts have been thoroughly boiled, derusted with wool, and protected with Renwax, and subsequently oiled. However, a few difficulties came in assembly ;(. Sorry, no pics. A friend borrowed my camera.

How is the carry handle sleeve retained on the barrel? I see a recess cut into the barrel, and holes on the sleeve, but I do not know what keeps it in place.

In the parts kit, I have found two small ball bearings. Where do they go and what are they for? How are they retained?

Thanks in advance for your help!

MEERKOOS