Thanks for the information.

I will try and bed it and leave the gap between the draws and stiple the timber surfaces to try and maximise adhesion. I was going to use a purpose made bedding kit for the majority of the work but also thought about using PC-7 or a similar thicker "putty" type adhesive to build up the draws before doing the pour.

If I later find that the epoxy draws are starting to crack, give way or am otherwise unhappy with them, I can grind them out and replace them with timber (or even copper block faces?).

I will use the wrist/fore-end contact and the height of the action resting at the front trigger guard screw for reference points.

If any one else has tried this method let me know.

And sorry Cinders, I fixed the video up and it should work now.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.