-
Legacy Member
WWII German Binoculars
I found these binoculars cleaning at my in-laws house. Initial research would indicate that they are WWII vintage. The case is not marked and I can't find a way to date the binoculars. I appreciate any input.
Also, what are the tabs on the bottom for?
Ron
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
Thank You to RangeHound For This Useful Post:
-
05-28-2017 05:00 PM
# ADS
Friends and Sponsors
-
Legacy Member
It would seem that Hensoldt are still in business, in Germany
.
Our Heritage : HENSOLDT
I would guess that the tabs are so that the case can be clipped onto a bracket inside a vehicle, ship, aircraft, etc etc.
Last edited by Flying10uk; 05-28-2017 at 07:23 PM.
-
Thank You to Flying10uk For This Useful Post:
-
-
Contributing Member
I am wondering if the small M denotes fit for "Marine" usage seems logical with the tabs being clipped to a bridge or fly bridge (in fine weather)
-
-
Legacy Member
'Tis a wartime Bakelit case, whatever they were intended for otherwise, the clips on the back were used for straps to secure the case to the Tragegepaeck.
The pic of the bino right tube cover shows a stripe- an you tell if it read Dienstglas at one time? Often there is other data on this tube side as well (H6400, etc)
Bakelit is a thermosetting emulsion using material filler from sawdust to cloth fiber. I've run into various shades of the Bakelit cases, from red to black. It often depends on the maker and what they used for fiber to fill out the emulsion. There is usually a cast mark in the well with the Bakelit maker and mix type, the number above the 'M' is the manufacturer, the sideways number is the composition material. These were not usually cast with maker codes (that was already in the mark) nor with date codes. Nice find! Many of these have cracks from being dropped over the years.
-
The Following 3 Members Say Thank You to matthanne1 For This Useful Post:
-
Legacy Member
I don't recall seeing red/brown bakelite cases for sale before at militaria shows only black ones which always seem to be eye wateringly expensive. Perhaps the red/brown type is less common?
-
-
Legacy Member
I've seen a lot of the black ones, granted, but over the years saw several others, two red/brown ones stick out in my memory- one was on a militaria display in Massachusetts in 1979 and one was basically trashed (had been crushed) for sale in a Berlin flea market when I was there in 1986-87. Guess they are less common after all!
-
-
Legacy Member
Here's the mold mark inside.
-
Thank You to RangeHound For This Useful Post:
-
Legacy Member
My ref doesn't list "OF" as a yet known maker among hundreds, but the "T2" indicates Phenolic Resin with asbestos and other organic fibers as the filler material.
-
Thank You to matthanne1 For This Useful Post:
-
Legacy Member
Is that a "M.D." trade mark in a circle with "OF" above?
-
-
Legacy Member
It is a 'pressmark', the official marking approved by the MaterialPruefungsAmt and used by members of the German
phenolic resin manufacturing 'society', an agreed upon way to mark maker and material used in the composition. Started around 1930s, ended at the end of WW2. Top digraph is the maker code, lower is the composition. As some compositions looked like years (two numbers, eg 43 which was actually Dynamit AG), some people thought they were date codes. They are NOT date codes, just maker and composition.
-
Thank You to matthanne1 For This Useful Post: