What slide is needed?

[chopperbobby]

I have a winchester carbine with a rockola slide. I think I want to put all winchester parts in it. What slide do a need for a sn: 5751XXX? Type 4, 5 or 6?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[imntxs554]

One of my Winchesters is in the same Range as yours and has the Type 5 Slide. So that's what you should have. But I seen this Range with and without the Part Number on it. Hope this helps.

[cali201]

Type 5, began around late 5.5--early 5.6

[chopperbobby]

thanks I was thinking 5 or 4

[painter777]

Chopperbobby,
Did you get your Bolt straightened out with the brass ejection problems?

Charlie-Painter777

[joz]

Which Rock-Ola slide do you have and do you want to sell it?

[painter777]

I want to put all winchester parts in it

Is this the one with the Underwood barrel?

Charlie-Painter777

[JimF4M1s (Deceased)]

Which Rock-Ola slide do you have and do you want to sell it?

This forum is not for selling or trading. Please use the classified or send private messages.

Thank you, Jim

[chopperbobby]

Is this the one with the Underwood barrel?

yes it is.

---------- Post added at 07:17 PM ---------- Previous post was at 07:14 PM ----------

Did you get your Bolt straightened out with the brass ejection problems?

got new springs. Have not gone shooting yet. I currently have it broken down and trying to identify the part. Just got my carbines wartime production book today. by craig riesch Helping a lot.

---------- Post added at 07:17 PM ---------- Previous post was at 07:17 PM ----------

Which Rock-Ola slide do you have

I think it is a 4