Magazine makers' initials

[painter777]

A length of 1"x 3" will get you rolling. Face sand to get it down to aprox 5/8" and the side to get down to about 1-3/4".
Round off the edges to fit inside mag profile. When you can slide one in, try inserted at 2", to see if correctly eliminates space of 5 rds.
Once you've got the profile, just cut to needed lengths.
Country boy way........... but trust me it will work ;-)

Grab your belt sander....

Cheers
Charlie-P777

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.