Cleaning up old computer....Brit No7 Bolt how to

[Hal O'Peridol]

Found these instructions on one of my old hard drives. From back in the old Mark Bitting dats.

Springfield Sporters had given up on their FFL and sold off LOTS of incomplete guns, and this included their stash of British No7 barrelled actions. Nut no other parts.

One of the members there cobbled up a way to use No8 bolts which were slightly less made of unobtanium.

So here's a copy of the process, Even though the page numbering is off, the article is all there.

It would be nice to sticky this as I will be shutting down my **** poor website soon and the pics will be lost then. It is at best a single shot conversion for the bolt. You could use a Canadian style CNo7 magazine for feeding. A single shor is better than a wallhanger.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Lee Enfield]

That was a fun forum

[p2v5f]

I shortened a NO4 bolt body and rethread it.
shortened the strike, rethread and ground it to a flat surface.

Had Canadian NO7 bolt head modified to match the contour and feed ramp of British NO7.

I have since obtained complete British bolt.

Any one have unneeded barrel receiver?

Bob

[Bruce_in_Oz]

Page 3?

Is that the one with the "racy" girlie pics?

[Hal O'Peridol]

Page 3?

Is that the one with the "racy" girlie pics?

Just pics of "strippers".