Some new things, lets play a guessing game

[Peter Laidler]

NOT the FN if we're being pedantic and I can steal BAR's thunder. But for re-rivetting L1 bayonet grips. It also requires another tool, the bit you knock down with the hammer to spread the rivets properly from each side. Hopefully........ But it doesn't work like that. The RIVETS, tubular, aircraft would inevitably split so you'd have to start again. We used to call them RIVETS, tubular, awful!

---------- Post added at 06:48 PM ---------- Previous post was at 06:46 PM ----------

I don't remember those BFA's in Oz or the UK but I'd say for tightening up the rivets for the detent spring on the choke

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

re-rivetting L1 bayonet grips.

Rifle bayonets though...? Thus my meaning of FNs...it would work on ours for sure. Yes, there's another piece to sandwich it.