[1915 Dated] 1903 Springfield

[browningautorifle]

Thanks! any suggestions on where to buy a liner

Matter of fact, there's a member here that did them to a pistol caliber, not .22. They have a much lower pressure and would have perhaps a 30 cal bullet so you could use the standard barrel, different chamber. I'd take a suitable barrel and sleeve a new chamber into it for say...7.62 x 25...use a different mag follower so it acted as a feedway and you'd have to sort your extractor out...

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[rcathey]

I'd take a suitable barrel and sleeve a new chamber into it for say...7.62 x 25....

Oh my...I like that idea even better. Bit of a zip (more than 22) and still cheap to plink around with. I’ll have to file that one away, Jim. Very cool idea.

[usabaker]

Didn't the Pedersen device use 7.65×20mm ?

---------- Post added at 05:49 PM ---------- Previous post was at 05:46 PM ----------

Just looked it up... YUP I'll just buy a Pedersen Device only cost me between Estimate Price: $40,000 - $60,000

https://www.rockislandauction.com/de...us-1903-mark-i