-
Legacy Member
DIY Inlet on a Lee Enfield stock
Has anybody inletted a standard stock to fit for the volley sights and mag cut off? If so was it difficult? If not, I’ve got a MK1 that needs all the bells and whistles.
Thanks, Cameron
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
02-23-2018 07:16 PM
# ADS
Friends and Sponsors
-
Legacy Member
the left side of your fore-end has to be thicker in order to inlet the dial plate
-
-