-
Legacy Member
The pistons were shimmed in order to achieve the correct amount of articulation. That is, when the piston and piston extension is inserted into the gun the piston MUST enter the conical entrance to the gas cylinder without assistance and not foul on any part of the surrounding area or the rear of the cylinder
How do I still remember this crap? Must be from when I did one!!!!!
Where did the shims come from? I have been unable to find a part listing for them. Were they steel?
-
-
04-05-2018 07:56 PM
# ADS
Friends and Sponsors
-
Advisory Panel
Rockape26 Join Date Mar 2018
Last On Mar-31-2018 @ 06:36 AM
Didn't even come back for the answer...
-
-
-
We used to make the shims from brass using a little locally made press tool.
-