Cocking Piece Nose/Sear Adjustment

[30Three]

I made a small rig to surface the cocking piece for my No1 mkIII* that I use in competitions.
Ideally I would like to get one machined out of metal; but the wooden version works quite well as a test piece. Certainly better than trying to do it by hand.
The cocking piece angle can be adjusted by a screw under piece in the lower part of the channel. I use a very fine Arkansas stone and oil and take it slowly.
IIRC the standard rifle is 4° off the right angle and the L39A1 target rifle is 10°.
Attachment 93626Attachment 93627Attachment 93628Attachment 93629

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.