-
Legacy Member
early 1941 production Winchester M1 rifle stock
Winchester obviously used fancy walnut,Attachment 95216Attachment 95217 that had been set aside in their custom shop, in
production of M1 rifle stocks to complete their early production order.
Photo of an early WRA RS no-trap stocks shows deluxe fancy walnut which was originally intended for a custom grade rifle. I have seen a few other nice stocks but everything appears to date from early 1941
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
The Following 11 Members Say Thank You to RCS For This Useful Post:
Bill Hollinger,
Bob Seijas,
cgroc09,
frankderrico,
HOOKED ON HISTORY,
Joe W,
Jonzie,
lgr1613,
Mark in Rochester,
Steve762,
Tom in N.J.
-
08-16-2018 10:24 AM
# ADS
Friends and Sponsors
-
Contributing Member
Yes, they are known for it in the early days. I wonder how they got around the spec for "straight-grained walnut."
Real men measure once and cut.
-
-
-
Legacy Member
Maybe they were mainly used on Educational Order rifles as the first 500 didn't have to function, if I remember correctly.
-
-
Contributing Member
WRA
I doubt it. Once the war started there was a pretty fierce battle for raw material, and WRA's priority rating was inexplicably low. At one point they were almost out of steel, threatening a complete halt to rifle production. That's when they dug into their stockpile of pre-war commercial chrome-moly steel (those CM Winchester parts) without permission from Ordnance. I'm guessing the same happened with wood.
Real men measure once and cut.
-
Thank You to Bob Seijas For This Useful Post:
-
Legacy Member
That makes sense. Thanks.
-
-
Moderator
(M1 Garand/M14/M1A Rifles)
A museum nearby has a presentation Garand with a figured stock that is quite pretty.
Bob
"It is said, 'Go not to the elves for counsel for they will say both no and yes.' "
Frodo Baggins to Gildor Inglorion, The Fellowship of the Ring
-