Swiss 1911 disappointing?

[amadeus76]

Think about starting to reload. Buy a used press if money is tight.
PPU has not been accurate in any of the lots I tried.
Good source for brass though.
Action screws should be checked before tou start shooting.
Torquing to a spec not really needed. Front screw tight, but not so much to risk damaging screw.

I will eventually reload for the caliber, I was (still am?) just unsure whether to go with dies for 7.5 Swiss or 7.5 Swiss (K-31) or if it really matters for my Swiss rifles... And honestly I'm in the middle of a PCS move so won't have my reloading set up available for another few months anyway.

I have tightened my action screws tho, and while I don't remember what my groups were the last time I took the rifle out I didn't get the vertical string I did when I started this thread.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[RC20]

I am guessing 1/2 MOA.

I am lucky to get that on a good day with my Bull Barrel 30-06 or my build up 7.5 Savage with a Lothar Walther barrel.