The rear hand guard retaining ring was with the sporterized rifle on purchase, even though there was no rear upper hand guard. I think kits original, I can’t imagine why it would have been switched out. It’s not broken or obviously bent in any way. The new rear upper hand guard was bought as part of a set sold as a no4 mk1 set, and the forward upper hand guard fits fine, lines up fore and aft and side to side. The rear guard is short fore and aft against the new forestock, and the placement of the retaining ring seems the same in the old sporterized stock and the new full wood stock.

Anyone who can offer measurements would be very helpful, as I don’t want to order a bunch of parts without knowing what it is I’m actually looking for!

I do not have an *advanced* button on my screen, perhaps because I’m using an iPad. I’ll try to fire up a PC and see if that helps.

Thanks all for your assistance!
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.