Looking for a Ross MKII magazine cutoff and spring

[Brownac1983]

Hey guys. I just picked up my first Ross, it's a MKII 3* and I need a little direction. I got it from an auction and it's missing a few small parts. I've already located the follower and I believe a rear stock crossbolt, but I've had no luck so far with the mag cutoff assembly.

Does anyone here have a mag cutoff assembly, or know of a source? Does the cutoff assembly perform any other function, or is the rifle safe and operable without it?

Is an exploded view/parts diagram available? I can't find one anywhere.

Thanks.
-Drew

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[breakeyp]

I got the parts from Numrich/Gun Parts a few years ago. They were as new.

[tiriaq]

I might have a cutoff. Will check tomorrow.

[Brownac1983]

I got the parts from Numrich/Gun Parts a few years ago. They were as new.

I checked Numrich. They list the parts but they're out of stock.

---------- Post added at 04:21 AM ---------- Previous post was at 04:20 AM ----------

I might have a cutoff. Will check tomorrow.

Thanks. Let me know if you find it.