Vintage military box identification

[fancoisvstar]

I have recently acquired this metal and cardboard box , does anyone have any idea what use for ? and where come from ?? Attachment 105210Attachment 105209Attachment 105208Attachment 105211

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

I would suggest it's exactly as stenciled, a tool box. Probably a general issue item. If you go looking you'll find all manner of descriptions and shapes.

[RASelkirk]

That looks extremely well preserved for being 77 years old. Are you certain of it's authenticity?

Russ

[fancoisvstar]

I did a lot of research and I can't find anything, and yes well preserved but too good and strong for reproduction..... mistery for me ??

[Brit plumber]

I don’t think it’s a repro, it could easily have sat in a depot for decades. As a general purpose tool chest it likely would not be removed from service for disposal like a specific kit would after being made obsolete. The lid suggests it’s been exposed judging by the colour.

As an example, in 2003 I found a spring balance in a kit in a cupboard and it was for testing the springs on the I’ll fated Harrier 25mm cannon. It turned out to be a Vickers/Enfield trigger tension gauge. New, never used but still technically in service.

---------- Post added at 09:48 PM ---------- Previous post was at 09:47 PM ----------

Oh and SE Co must be Sterling Engineering.