m1903 refurb

[cplstevennorton]

. Long term consideration is a Hi-Lux USMC unertl and c-stock. I already have the latter from a different project. Last question - would the mounts hold sufficiently with lactate, without being soldered as well? I'd like the minimal option of switching back to its original configuration (sans the barrel and receiver tapped holes of course).

None of the original Unertl Snipers had the mounts soldered to the rifle that I have seen.

I'm trying to figure out what Lactate is though. lol I'm not sure what you mean by that.

But the originals were drilled and tapped and screws hand tightened.

I was hoping I had a better pic, but this is the best I have on my computer without taking a new one.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.