-
Legacy Member

Originally Posted by
bml
I was watching that one out of curiosity. The seller is local and has had a few rifles for sale lately. 15’ away it looks nice. Up close there is a lot of issues. Most of the parts have a problem. The receiver is almost certainly welded, machine lines don’t line up. The stock is cracked. The gas cylinder is cut. Not much left to work with.
Nothing wrong with the cut in the cylinder, done at the arsenal.
Former Prairie Submarine Commander
"To Err is Human, To Forgive is Divine. Neither of Which is SAC Policy."
-
The Following 2 Members Say Thank You to AFJon For This Useful Post:
-
03-12-2020 12:06 PM
# ADS
Friends and Sponsors
-
Advisory Panel

Originally Posted by
AFJon
the cut in the cylinder
That's right, they were done so the front would tighten up on the barrel. Less rotational wobble...
-
Thank You to browningautorifle For This Useful Post:
-
-

Originally Posted by
bml
The gas cylinder is cut.
I'm new to these rifles. It looks like a saw cut. Is that from de-milling operations? Welcome to the Forum! - Bob
Oops! Didn't see the posts on Page 2 explaining the "gas cylinder cut" when I responded earlier today.
Last edited by USGI; 03-13-2020 at 01:07 AM.
Reason: I screwed up!
-
-
Advisory Panel
I repaired/tuned and stocked up a reweld M1
Rifle just like it a couple of years ago for a guy in Palm Desert, California. It was a good shooter when i was done. The welds are not in a critical area. They aren't uncommon and are what they are.
-
-
The welds are not in a critical area. They aren't uncommon and are what they are.
Is the reason because the welds are behind the main bolt locking lugs? - Bob
-
-
Legacy Member
The welds are not in a critical area. They aren't uncommon and are what they are.
I bet they’d seem pretty “critical” if you realized they were there after spending $1,300 on the rifle
-
-
Advisory Panel
I think the welds are in the middle because that was the easiest place to cut them in the first place.
I'm talking about safety not finance. You just can't fix stupid when it comes to some folks who buy everything at auction. You also can't keep the sellers from being fraudulent which is what it is. That being said, in the period of time between 1968 and 1986 when good M1
Rifles were in short supply, many demilled receivers got rewelded and many rifles built using them. Some were beautifully done and some not. The one I repaired and restocked was nicer than the one we're talking about here but it was still pretty obvious. At least to me. Most if not all are functional either way. They're out there so caveat emptor.
-
Thank You to Brian Dick For This Useful Post:
-
Legacy Member
You just can't fix stupid when it comes to some folks who buy everything at auction.
That’s pretty much the long and short of it!
-
-
-