They're here! Reproduction No32 scopes.

[tr63]

I too just received a MkII from Gun Parts Corp, and it looks like a decent quality reproduction. I do however believe that I have an issue with mine (unless I am completely missing something here). Once mounted into a reproduction No 4T mount on my No 4 T rifle the reticle is canted counter clockwise by about 5 to 7 degrees, which is very noticeable. I have been reading all of the mounting and adjusting instructions and am to this point under the assumption that there is no adjustment for this since the scope has the small peg screw that locates into the slot on the mount. Im quickly thinking I may have gotten a defective one. Anyone else seen anything similar on these?

Your mount has a recessed area at the bottom of the front ring this is for the scope's dowel locating pin . this will have to be enlarged from the center line of the recess right and left this will allow you to cant the scope to center your scope cross hair and post . Also be aware of the fit of the scope in the front ring ,most of the after market scope mounts including the ones made by RSM are way out of specification and when the rings are fitted they will bind in the scopes area to receive the rings .If it dose you have to shave the face and the rear of the rings to insure there is no binding .I had a original No 32 MkI scope the would not a line the post and cross wire unless the after market mount was reworked as stated above . Never remove metal from the scope . Remove metal from the mount it is the lest expansive item and if you make mistake it is ease to replace.