And, put the Dremel away! Use a rat tail file or rasp to remove wood in the hole. The Dremel removes hundredths of an inch when microns are needed!

The sleeve should not extend below the wood. Use a wood dowel to gently tap it up into place.

With the action removed, put the TG in the stock. Looking through the guard screw holes, are the holes centered above the holes in the TG? Leaving the follower & spring aside, add the bbl & receiver. Start the front screw a thread or two. Then start the rear. If the rear won't catch, reverse order; start the rear first, then the front. Then & only then use the rasp to slowly enlarge the holes in the stock. Put the Dremel in the fridge.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.